MITSUBISHI ELECTRIC CP700E - Manual (Page 21)

20
4. Connection with external equipment (RS-232C Interface)
Setting BAUD RATE
1 Press the DOWN or UP shift buttons to select “BAUD RATE” .
The set baud rate, for example, “9600” , is displayed.
Press the RIGHT or LEFT SHIFT button to select “1200” ,
“2400” , “4800” or “9600” Bit/Sec) .
2 Press the SET
SET
button.
, “CHANGE : OK” is selected.
, Press the RIGHT or LEFT shift button to select “OK” or
“CANCEL” .
3 Select “OK” , then, press the SET
SET
button.
, “Memory SW Main Menu” is displayed.
4 Press the SET
SET
button.
, “CHANGE : OK” is selected.
5 Select “OK”, then, press the SET
SET
button.
, The source image (input signal from the equipment connected) is displayed.
0 The setting of BAUD RATE is completed.
S y s t e m S e t M e n u
B A U D R A T E : 9 6 0 0
S y s t e m S e t M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
5 . S Y S T E M S E T : P U S H [ > ]
S y s t e m S e t M e n u
C O M M A N D T Y P E : A
S y s t e m S e t M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
5 . S Y S T E M S E T : P U S H [ > ]
Setting the RS-232C COMMAND TYPE
Select “A” or “B” according to the equipment connected.
1 Press the DOWN or UP buttons to select “COMMAND TYPE” .
Press the RIGHT or LEFT SHIFT button to select “A” or “B” .
2 Press the SET
SET
button.
, “CHANGE : OK” is selected.
, Press the RIGHT or LEFT button to select “OK” or
“CANCEL” .
3 Select “OK” , then, press the SET
SET
button.
, “Memory SW Main Menu” is displayed.