MITSUBISHI ELECTRIC CP700E - Manual (Page 17)

16
4. Connection with external equipment (Monitor)
Setting the output sync. signal “OUTPUT SYNC”
5 Press the DOWN or UP button to select “OUT SYNC” .
, The set level of the sync. signal, for example, “0.3V” is displayed.
Set the sync. signal according to the equipment to be connected.
Press the RIGHT or LEFT button to select “0.3V” or
“TTL” .
0.3V ...... 0.3Vp-p
TTL .... TTL level
Setting the output RGB Analog signal “RGB SOG OUT”
6 Press the DOWN or UP button to select “RGB SOG OUT” .
7 Press the RIGHT or LEFT button to select “ON” or “OFF” .
OFF...... Outputs Composite Sync. signal
ON ...... Outputs Sync. On Green + Composite Sync. signal.
Select “ON” or “OFF” according to the monitor to be connected.
8 Press the SET
SET
button.
, “CHANGE : OK/CANCEL” is selected.
Press the RIGHT or LEFT shift button to select “OK” or
“CANCEL” .
9 Select “OK” , then press the SET
SET
button.
, “Memory SW Main Menu” is displayed.
A Press the SET
SET
button.
, “CHANGE : OK” is selected.
B Select “OK” , then press the SET
SET
button.
, The source image (input signal from the equipment) is displayed.
0 The setting of the sync. polarity and signal is completed.
S i g n a l A d j M e n u
O U T S Y N C : T T L
S i g n a l A d j M e n u
R G B S O G O U T : O F F
S i g n a l A d j M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
3 . S I G N A L A D J : P U S H [ > ]