Printing procedures (special prints), 1setting the separate function – MITSUBISHI ELECTRIC CP700E User Manual
Page 76
75
1
OPERATION
1
Setting the multi-print and photo-print menus
Setting multi-print and photo-print functions
1
Press the MENU button. Then, press the UP
or DOWN
shift button to select “3. ADDITIONAL PUSH [
]”.
3
Press the DOWN
shift button to select “MULTI : OFF/ON”. Then press the RIGHT
shift button to select “ON” .
4
Set the multi-image type (2, 2s, 4 or 16) or photo print size.
,
“MODE : SAME/DIFF/PHOTO” is displayed on the menu screen.
,
“IMAGES : 2 / 2s/ 4/ 16” is displayed on the lower line.
,
Set “MODE : SAME/DIFF/PHOTO” and “IMAGES : 2/2s/4/16 or CARD/3*4/5*5” menus.
,
Refer to
1
MULTI PRINT and
2
PHOTO PRINT for the multi-image type.
2
Press the RIGHT
shift button to select “3. ADDITIONAL”.
1
Setting the SEPARATE function
5
Press the DOWN
shift button to select “SEPARATE : OFF/ON” .
6
Press the RIGHT
shift button to select “ON”.
1
Displaying the source image (image from the input signal)
7
Press the SET
SET
button.
,
“CHANGE : OK/CANCEL” is selected.
,
When changing the setting, select “CANCEL”.
8
Press the SET
SET
button.
,
The MAIN MENU is displayed.
9
Press the SET
SET
button.
,
“SAVE PRG 1/2/3” is selected.
,
This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
A
Press the RIGHT
or LEFT
shift button to select the program number 1, 2 or 3 to store the setting.
,
The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is
stored.
8. Printing Procedures (Special prints)