MITSUBISHI ELECTRIC CP700E - Manual (Page 70)

69
8. Printing Procedures (Special prints)
3 Press the DOWN or UP button to select “MULTI : OFF/ON”. Then, press the RIGHT button to select
“ON”.
, “MODE : SAME/DIFF/PHOTO” is displayed on the menu screen.
4 Press the DOWN button to select “MODE : SAME/DIFF/PHOTO”. Then, press the RIGHT button to
select “SAME” or “DIFF”.
, When “SAME” is selected, a multi-image (2, 2s, 4 or 16 images) of the same image can be printed.
, When “DIFF” is selected, a multi-image (2, 2s, 4 or 16 images) of the different images can be printed.
5 Press the DOWN shift button to select “IMAGES : 2/2s/4/16”. Then press the RIGHT shift button to select 2, 2s,
4 or 16.
, The multi-image setting is completed.
, When “2” or “2s” is selected, 2 images can be stored in memory.
, When “4” is selected, 4 images can be stored in memory.
, When “16” is selected, 16 images can be stored in memory.
1
Displaying the image from input signal (source image)
1 Press the SET
SET
button.
, “CHANGE : OK/CANCEL” is selected.
, When changing the multi-print function, select “CANCEL”.
2 Press the SET
SET
button.
, The MAIN MENU is displayed.
3 Press the SET
SET
button.
, “SAVE PRG 1/2/3” is selected.
, This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
4 Press the RIGHT or LEFT button to select the program number 1, 2 or 3 to store the setting.
, The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is
stored.
5 Press the SET
SET
button.
, The source image (image from the input signal) is displayed.
, “IMAGES : 2 / 2s/ 4/ 16” is displayed on the lower line.