MITSUBISHI ELECTRIC CP700E - Manual (Page 78)

77
1
Setting 1-image/multi-image memory
8. Printing Procedures (Special prints)
1
When memorizing 1 image in STROBE mode
This setting is used to memorize 1 image in memory page [A B] (FRAME) or [A B C D] (FIELD).
1 Set the mode to 1-image.
Select “OFF” in “MULTI : OFF” in “3. ADDITIONAL”.
2 Set the page increment function to ON.
Set the “PAGE INC” to ON in “6. SYSTEM”. (The initial setting is “ON”.)
, In FRAME mode, the image is memorized in the stored in memory page in order of page [A]
→
page [B]
→
page [A]....
, To memorize images in page [A] and [B] only once, (not memorizing images repeatedly) set “MEM&STOP” to“ON” in “2.
KEY SET” from MEMORY SW MENU.
, When “PAGE INC” is set to OFF, images are memorized in page [A] repeatedly.
1
When memorizing multi- image (2, 2s, 4 or 16 images) in STROBE mode
This setting is used to memorize multi-image in order in one memory page.
1 Set the mode to MULTI.
Select “ON” in “MULTI” in “3. ADDITIONAL”.
2 Set the number of images and print size.
Set “MODE : SAME/DIFF/PHOTO” and “IMAGES : 2/ 2s/ 4/ 16” in “3. ADDITIONAL”.
, Refer to 1 MULTI PRINT for setting the number of multi-image.
, When “DIFF” is selected in “MODE” and 2, 2s, 4 or 16 is selected in “IMAGES”, 2, 2s, 4 or 16 images are stored in memory
in order at the set interval.
When the images are fully stored in memory page, the strobe memorization stops.
, When “MODE” is set to “SAME” or “PHOTO”, the memorization status is as same as one image memorization.