MITSUBISHI ELECTRIC CP700E - Manual (Page 11)

10
Menu display
When setting the day and present time , use the menu on the LCD display.
Also use the menu when selecting each setting after connecting an external device or selecting the print size (S /L).
,
There are 2 menus, Main menu and Memory SW menu.
,
Each menu is displayed as shown below.
MAIN MENU Memory SW menu
0 Setting the present time
Refer to pages 11-13.
0 Setting the polarity.
Refer to pages 15-16 .
0 Setting the print paper.
Refer to pages 31-32 .
0 Setting the baud rate.(RS-232C)
Refer to pages 19-21 .
0 Setting input signal.
Refer to pages 29-30.
, For each setting, refer to the pages above.
Use the remote control to set the functions.
3. Preparations before operation
Memory SW Main Menu
1.TIME ADJ : PUSH [ ]
2.KEY SET : PUSH [ ]
3.SIGNAL ADJ : PUSH [ ]
4.PRINT SET : PUSH [ ]
5.SYSTEM SET : PUSH [ ]
CHANGE : OK
CANCEL INIT
MEMORY
POWER
+
Pressing the POWER button to
display MEMORY SW menu
while pressing MEMORY button. Press the menu button to
display the Main menu after
pressing POWER button.
Memory SW menu
MENU
NORMAL PRG.1 Q'ty 1
Page:A FIELD RGB
MAIN menu
Normal display
SET
POWER
Selecting the
input signal
Setting the day and present time
Setting the polarity
Setting the print paper
Setting the baud rate (
RS-232C)
SET
OK
Main Menu
1.COLOR ADJ : PUSH [ ]
2.SIGNAL SET : PUSH [ ]
3.ADDITIONAL : PUSH [ ]
4.PRINT : PUSH [ ]
5.COMMENT : PUSH [ ]
6.SYSTEM : PUSH [ ]
SAVE PRG : 1 / 2 / 3