MITSUBISHI ELECTRIC CP700E - Manual (Page 19)

18
4. Connection with external equipment (RGB Analog signal)
3
Connection with RGB Analog Signal equipment
, When connecting the unit with another equipment, make sure to set the power of each equipment to “OFF”.
, Use BNC type cable on the market for connection.
, This unit functions at 15.625 kHz for H and 50Hz for V.
Setting the switches
, Set the impedance switches “IMPEDANCE” on the rear panel to the impedance of the equipment connected.
Normally,
a.Set the RGB analog signal to “75
Ω
”.
b.Set the sync signal to “HIGH.
NOTE: • When the power turns off or the display is not appeared with analog through mode, the impedance switch is not
available. So, connect the unit with the side of monitor or external terminal .
• When connecting to a monitor, use the monitor with 75
Ω
.
75 Ω
HIGH
75 Ω
HIGH
IMPEDANCE
SYNC.
RGB
Impedance switch for RGB analog signal
Impedance switch for sync. signal
AC LINE
R G/G+SYNC B H+V-SYNC
R G/G+SYNC B H+V-SYNC
IN
OUT
S-VIDEO
VIDEO
75 Ω
HIGH
75 Ω
HIGH
IMPEDANCE
SYNC.
RGB
RS-232C
RECORD
REPLAY
10 KEY
RED
GREEN GREEN
BLUE BLUE
CONTRAST
BRIGHTNESS BRIGHTNESS
SCAN SPEED
RESET RESET WHITE BALANCE
SCAN START
POWER
ON OFF
R G/G+SYNC. B H+V-SYNC.
To RGB Analog OUT terminal
R G/G+SYNC. B H+V-SYNC.
To RGB Analog IN
terminal ( )
VCP
RGB Analog signal equipment
In case of SYNC ON G.
signal, it is not
necessary to connect to
the unit.
REMOTE
1 2