Minicom Advanced Systems DX System - Manual (Page 8)

DX SYSTEM
7
Reduced airflow
Install the equipment in a rack in such a way that the amount of airflow required for
safe operation is not compromised. Leave a gap of at least 5cm/2” each side of the
DX Central unit.
Mechanical loading
Mount the equipment in the rack in such a way that a hazardous condition is not
achieved due to uneven mechanical loading.
Circuit overloading
When connecting the equipment to the supply circuit, consider the effect that
overloading of circuits might have on over-current protection and supply wiring.
Reliable earthing of rack-mounted equipment should be maintained. Give attention
to supply connections other than direct connections to the branch circuit (e.g. use of
power strips).