MACKIE DIGITALXBUS X.200 - Manual (Page 25)

25
Owner's Manual
Owner
's Manual
Copy Filtered… (Ctrl+Shift+C)
• Opens the COPY FILTERED window. This al-
lows you to select the individual channel param-
eter data to copy to the clipboard.
These parameters include:
Fader Dynamics
Mute Buses
Pan Phase
Auxes Surround
EQs Assigns
• The selected channels parameter settings are
not changed.
• The data on the clipboard can be pasted to an-
other channel. Only the selected parameters are
pasted into the new channel. The unselected
parameters are left intact.
• You can use the Undo command (Ctrl+Z) to
undo a Copy Filtered command.
Paste (Ctrl+V)
• Replaces the parameters in a selected channel
with the data in the clipboard.
• The data on the clipboard remains intact, so it
can be pasted to multiple channels.
• You can use the Undo command (Ctrl+Z) to
undo a Copy command.
Modify Levels…
• Opens the MODIFY LEVELS window. Use this
control to modify individual parameters for the
selected channel(s).
The Edit Menu
Contains:
Undo (Ctrl+Z)
Redo (Ctrl+Shift+Z)
Cut (Ctrl+X)
Copy (Ctrl+C)
Copy Filtered… (Ctrl+Shift+C)
Paste (Ctrl+V)
Modify Levels…
Insert Global Time…
Delete Global Time…
Clear Automation
History List (Ctrl+H)
Clear History
Copy Mix To Bus
Undo (Ctrl+Z)
• Reverses an action. If you’ve made a bad
automation pass, cut something you didn’t re-
ally want to cut, pasted somewhere you didn’t
want to paste, etc., simply select Undo (or type
Ctrl+Z on the keyboard) and the Digital X Bus
reverts to its previous state.
• Selecting Undo multiple times steps back
through the history list (list of actions taken),
all the way back to the top level (starting
point), if necessary. Open the History List
(Ctrl+H) to check it out.
Redo (Ctrl+Shift+Z)
• Reverses an Undo. If you’ve undone an action,
or set of actions, you might determine that your
original guess was best, and want to return to
actions you removed.
• Redo is a multilevel command, like Undo, so
multiple redo commands retrace your steps
through any undone actions in reverse order.
Cut (Ctrl+X)
• Copies all the selected channel’s parameter data
to the clipboard and sets the channel’s param-
eters to their default settings.
• The data on the clipboard can be pasted to
another channel.
• You can use the Undo command (Ctrl+Z) to
undo a Cut command.
Copy (Ctrl+C)
• Copies all the selected channel’s parameter
data to the clipboard and leaves all the selected
channel’s parameters intact.
• The data on the clipboard can be pasted to
another channel.
• You can use the Undo command (Ctrl+Z) to
undo a Copy command.