Minicom Advanced Systems SMARTRACK 116 IP User Manual
Smartrack 116 ip user guide
Table of contents
Document Outline
- 1. Welcome
- Section I
- 2. Introduction
- 3. System components
- 4. Hardware kit contents
- 5. Pre-installation guidelines
- 6. Connecting to a rack
- 7. The SmartRack Switch system configuration
- 8. Terminology
- 9. Initial settings - Default IP address
- 10. Logging into the Web interface
- 11. Network > Configuration
- 12. Network > SNMP Settings
- 13. Administration > User Settings
- 14. Administration > Switch Configuration
- 15. Administration > User Targets
- 16. Security > Settings
- 17. Security > SSL Certificate
- 18. Maintenance > Firmware Upgrade
- 19. Restore Factory Settings
- 20. Saving changes and logging out
- 21. Starting a remote session
- 21.1 Taking over a busy remote session
- 21.2 The Toolbar
- 21.3 Switching to a different server
- 21.4 Changing the performance settings
- 21.5 Adjusting the Video settings
- 21.6 Power cycle
- 21.7 Keyboard key sequences
- 21.8 Synchronizing mouse pointers
- 21.9 Minicom icon menu features
- 21.10 Full screen mode
- 21.11 Disconnecting the remote session
- 22. Troubleshooting - Safe mode
- Section II
- 23. Switching between computers
- 24. The OSD
- 25. Upgrading the SmartRack 116 IP firmware
- 26. Technical specifications
- 27. Video resolution and refresh rates
- 28. Safety
- 29. User guide feedback
- 30. WEEE compliance