Minicom Advanced Systems SMARTRACK 116 IP - Manual (Page 44)

SMARTRACK 116 IP
43
22.1 Entering Safe mode
To enter Safe mode:
1. Press and hold down the Local button for 3-4 seconds and at the same time
power up the SmartRack 116 IP. The device boots up in Safe mode.
2. Wait until the unit finishes booting (1-2 minutes).
3. You need to know the IP address of the SmartRack 116 IP. The IP address
depends on whether there is a DHCP server on the network. If there is, the
DHCP server assigns an IP address to the SmartRack 116 IP. If there is no
DHCP server, the unit boots with the static IP address 192.168.2.155. See
Figure 44 for an overview of this procedure.
Figure 44 Safe mode procedure
Open Internet Explorer and type the following into the Address box: http://IP
address/config. (Do not start the address with https). The Login page appears,
see Figure 45.