Stovax Studio 22 - Manual (Page 8)

8
6. FLAME FAILURE DEVICE
6.1 This is a safety feature incorporated on this appliance which
automatically switches off the gas supply if the pilot goes
out and fails to heat the thermocouple.
7. RUNNING IN
7.1 The surface coating on the metal used in your GAZCO fire
will "burn off" during the first few hours of use producing a
harmless and temporary odour. This will disappear after a
short period of use. If the odour persists, ask your installer
for advice.
8. SERVICING
8.1 The fire must be serviced every 12 months by a qualified
Gas Engineer. In all correspondence always quote the
Model number and the Serial number which may be found
on the data badge.
9. VENTILATION
9.1 Any purpose provided ventilation should be checked
periodically to ensure that it is free from obstruction.
10. INSTALLATION DETAILS
10.1 Your installer should have completed the commissioning
sheet at the front of this book. This records the essential
installation details of the appliance. In all correspondence
always quote the Model number and Serial number.
11. HOT SURFACES
11.1 Parts of this appliance become hot during normal use.
• Regard all parts of the appliance as a ‘working surface’
• Provide a suitable fire guard to protect young children
and the infirm
12. FIRE WILL NOT LIGHT
12.1 If you cannot light the Studio:
• Check that the emergency shut off switch is in the ON
(1) position, see Section 2, Emergency Shut Off
• Check and change the batteries in the remote handset
• Check and change the appliance batteries, Section 4.
Consult your Gazco dealer if the Studio still does not light.
12
AR2124
A
D
5.6 Put the groove in the base of Log E into the indent on the
right of Log A. The left branch rests on the upper end of Log
C, Diagram 13.
13
AR2125
A
E
5.7 Log F rests against Log B at its far right end, between Log
B and the side panel. The front end of Log F sits on the
front panel, see Diagram 14
14
AR2126
B
F
You must ensure the door catches are fully engaged:
• Slide the allen key into the gap between the door and
frame and locate the catch of the lower lock
• Push the allen key DOWN
• Slide the allen key into the gap and locate the upper lock
• Push the allen key UP
USER INSTRUCTIONS