Stovax Studio 22 - Manual (Page 33)

33
9
AR1888
10
AR2135
With all screws removed:
• Slide the control unit to the left
• Lift the right-hand side up and out
11
AR2128
7.4 • Disconnect the two cables marked 'A' in Diagram 12
12
AR1873
A
B
C
A
• Disconnect the battery extension lead, Diagram 12, B
• Disconnect the touch pad extension lead, Diagram 12, C
The control assembly can now be lifted up and removed.
• Reassemble in reverse order
8. PILOT UNIT ASSEMBLy
8.1 The pilot assembly consists of four components which can
be individually changed:
1. Pilot burner bracket
2. Pilot injector
3. Electrode
4. Thermocouple
Before commencing work on the pilot the Main Control
Assembly must be removed, see Section 7 above.
8.2 Pilot Burner Bracket
• Remove the electrode, see paragraph 8.3
• Remove the thermocouple, see paragraph 8.5
• Remove the pilot pipe
• Remove the two screws securing the bracket
The pilot burner bracket can now be removed.
• Replace in reverse order
• Check the pilot gasket and if damaged, replace with a
new one
8.3 Electrode
• Pull the ignition lead off the electrode and undo the
retaining nut, Diagram 13
SERVICING INSTRUCTIONS
REPLACING PARTS