Stovax Studio 22 - Manual (Page 32)

32
SERVICING INSTRUCTIONS
REPLACING PARTS
5. VERMICULITE PANELS
5.1 TAkE CARE WHEN HANDLING THE VERMICULITE
PANELS, THEy ARE FRAGILE.
Note: Make sure you support the back panel before removing
the second side panel in case the back falls forward
• Undo the clips at the top of the side panels
While supporting the rear panel:
• Remove each side panel and place to one side
• Remove the back panel
5
AR2138
• Remove the front lower panels
5.2 • Reassemble in reverse order, ensuring the bottom edge
of the back panel is behind the Air Baffle, Diagram 6
6
AR2139
• Replace the side panels
6. MAIN BURNER
6.1 To replace the main burner:
• Remove the logs and embers from the burner
• Undo the four screws holding the burner tray in place
• Lift the left side of the burner up and out first, Diagram 7
7
AR2117
6.2 To replace the burner:
• Lower the right-hand side over the injector
• Lower the left side down
• Insert the four fixing screws and tighten
NOTE: Before replacing the burner, make sure the silicone seal
around the injector is intact.
7. MAIN CONTROL ASSEMBLy
7.1 To access the main control assembly, first remove:
• the decorative frame if applicable
• the door
• vermiculite panels
• main burner
• air baffle
7.2 To remove the access panel:
• Undo the two screws, Diagram 8
8
AR2129
7.3 Isolate the gas supply at the isolation device and disconnect
the gas inlet, Diagram 9.
• Undo the 13 screws fixing the control unit in place