Installation instructions, Installation, Studwork for studio edge installation kit – Stovax Studio 22 User Manual

Page 19

INSTALLATION INSTRUCTIONS

INSTALLATION

• Fit the support bar into the studwork at the correct

height, Diagram 11.

AR1904

• Attach the 4 frame fixing brackets to the fire by placing

the top part of the bracket through the slots

• Push the bracket flat against the panel, then slide down

to the stop, see Diagram 12

AR1913

• Fix foam seal to the outer flange of the fire, Diagram 13

AR1913b

• Position the fire

• Fit non-combustible board to the studwork around the

fire. This should extend a minimum of 400mm above the

appliance and at least 50mm to the sides of the appliance

(from the outer box, not the flanges).

• Apply plasterboard to the remainder of the studwork

• Secure the fire back to the studwork using four screws

through flange, bracket, support bar

• Apply a plaster finish to the front of the chimney breast

Slips
Because of the high temperatures this fire achieves, it is advisable

to use marble slips or similar material between the appliance and

the plasterboard.

Never use a one-piece slip because expansion (even cracking)

can occur.

Note: If a slip is used, longer screws are needed to secure the

appliance.

To finish the installation:

• Connect the wall box and batteries following instruction

in Section 7 below

• Connect:

- the flue system (see Installation, Flue Assembly)

- and gas services (see Installation Section 9) using the

opening in the side of the chimney breast for access.

After commissioning:

• Finish the sides of the chimney breast, Diagram 14

AR1905

5. STUDWORk FOR STUDIO EDGE

INSTALLATION kIT

There is an optional Studio 22 Edge Installation Kit available for

installing the fire without a frame: Studio 22 BF Code No.

8727BFEK22. This consists of four metal brackets so that you can

create a flush finish to the "edge" of the appliance.

Using the installation kit:

• Fit the four metal brackets of the kit to the fire:

• Fit the sides to the appliance and secure using nuts and

washers provided

• Attach the top and bottom metal brackets to the top

and bottom flanges of the appliance using nuts

and washers provided, see Diagram 15