Installation instructions, Installation, Studwork for cool wall installation kit – Stovax Studio 22 User Manual

Page 21

INSTALLATION INSTRUCTIONS

INSTALLATION

6. STUDWORk FOR COOL WALL

INSTALLATION kIT

There is an optional Studio 22 Cool Wall Installation Kit available

for installing the fire without a frame: Studio 22 BF Code No.

8727BFCW22. This consists of four metal brackets so that you can

create a flush finish to the "edge" of the appliance.

For this cool-wall installation, the convected heat of the fire is

channelled into the studwork enclosure and vented at the top.

The cool wall installation kit is provided unfinished. This allows the

kit to be finished to match the fireplace decor.

Using the fixing kit:

• Fit the four metal brackets of the kit to the fire

• Line up the side brackets with the holes in the front

flange of the appliance

• Secure to the flange using the nuts, washers and bolts

provided, Diagram 20

AR2132

Note: Make sure the long side of the bracket is nearest

the inside.

This now determines the width of your two vertical

studwork supports. The kit has been designed so that non-

combustible board can be taken right up to the edge of the

four brackets, Diagram 21 & 22

AR2131

AR2082

• Ensure all clearances to combustible materials are

maintained, Section 3, 3.1

• Decide on flue requirements

• Cut a hole for the flue exit - see Installation

Instructions, Flue Assembly, Diagram 21

AR1902

• Secure the top bracket at each side into the studwork

using the screws provided

• Secure the bottom bracket to the flange using the nuts,

washers and bolts provided

Finally:

• Secure the outer part of the metal brackets into the

studwork, see Diagram 20 inset

There is a deliberate gap at the top for convected heat.