Stovax Studio 22 - Manual (Page 16)

16
INSTALLATION INSTRUCTIONS
INSTALLATION
IMPORTANT: REFER TO DATA BADGE AND TECHNICAL
SPECIFICATION AT THE FRONT OF THE MANUAL TO
ENSURE THE APPLIANCE IS CORRECTLY ADJUSTED FOR
THE GAS TYPE AND CATEGORY APPLICABLE IN THE
COUNTRY OF USE.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES
REFER TO SECTION 10, SERVICING, ‘REPLACING PARTS’.
1. SAFETy PRECAUTIONS
1.1 For your own and other’s safety, you must install this fire
according to local and national codes of practice. Failure to
install the fire correctly could lead to prosecution:
• Read these instructions before installing and using this
fire.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
1.4 Keep all plastic bags away from young children.
1.5 Do not place any object on or near to the appliance and
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
2. INSTALLATION OF THE APPLIANCE
REFER TO THE SITE REQUIREMENTS SECTION FOR ALL
FLUE OPTIONS.
This stove is suitable for top or rear flue exit.
• For top exit, read Section 8.2
• For rear flue exit, read Section 8.1
THERE IS AN OPTIONAL DUCT KIT, CODE No. 8572
WHICH CAN BE FITTED AT THE SAME TIME AS THE
APPLIANCE INSTALLATION.
2.1 • Remove the appliance from the carton and discard all
unnecessary packaging
• Ensure no components are thrown away when unpacking
2.2 To open the glass door, use the allen key provided:
• Slide the allen key into the gap between the door and
frame and locate the catch of the upper lock
• Push the allen key DOWN
• Slide the allen key into the gap and locate the lower lock
• Push the allen key UP
1
AR2119
AR2119
• Open the door outwards
2.3 The gas supply enters the fire through a silicon panel on the
floor or in the back panel of the fire, underneath the control
unit, Diagram 2
2
AR2130
AR2130
2.4 To access the gas pipe:
• Undo the clips on the upper inside holding the
vermiculite side panels in place, Diagram 3
3
AR2127
Vermiculite side panel
• Remove the two side panels and back panel and put to
one side
• Ensure the back panel is supported when removing the
side panels
TAkE CARE WHEN HANDLING THE VERMICULITE
PANELS, THEy ARE FRAGILE.