User instructions, Arrangement of fuel bed – Stovax Studio 22 User Manual
Page 7
7
USER INSTRUCTIONS
7
AR1932
5. ARRANGEMENT OF FUEL BED
ADVICE ON HANDLING AND DISPOSAL OF FIRE
CERAMICS
The fuel effect and side panels in this appliance are made
from Refractory Ceramic Fibre (RCF), a material which is
commonly used for this application.
Protective clothing is not required when handling these
articles, but we recommend you follow normal hygiene
rules of not smoking, eating or drinking in the work area
and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a
minimum, during installation and servicing a HEPA filtered
vacuum is recommended to remove any dust accumulated
in and around the appliance before and after working on it.
When servicing the appliance it is recommended that the
replaced items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable, non-reactive hazardous waste
and may be disposed of at a licensed landfill site.
Excessive exposure to these materials may cause temporary
irritation to eyes, skin and respiratory tract; wash hands
thoroughly after handling the material.
After cleaning the fire or replacing parts, carefully
re-assemble the ceramic components. WHEN THE EMBERS
ARE PLACED ON THE BURNER IT IS IMPORTANT THEy
DO NOT COVER ANy PORTS!
The fuel bed is made up of embers and 6 logs, identifiable
by moulded letters on their base:
5.1 Place the embers around the burner holes as shown in
Diagram 8. Do not cover any of the holes.
8
AR2120
5.2
Place Log A onto the two studs on the burner skin,
Diagram 9, with charred effect of the log facing forward.
9
AR2121
A
5.3
Place Log B on the ledge at the rear of the fire, Diagram
10.
10
AR2122
A
B
5.4
Place Log C so that the back end sits in the groove in the
rear of Log B and the front left rests in the cut-out groove
in Log A, Diagram 11.
11
AR2123
A
B
C
5.5 Position Log D so that the underneath rests in the groove of
Log A, and the triangular groove in the base of Log D fits
into the corner of the burner, Diagram 12.