Gateway 9315 - Manual (Page 91)

86 www.gateway.com
Replacing the control panel
To replace the control panel:
1
Follow the instructions in “Preventing static electricity discharge” on page 37 . Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
2
Unlock the bezel, then remove it by pulling it straight off the server.
3
Follow the instructions in “Opening the server case” on page 38 .
4
Press the blue latch at the back of the control panel, then slide the control panel
forward far enough to reach the front panel and USB cable connectors at the back of
the panel.
5
Disconnect the cables from the control panel.
Caution The control panel is not hot-swappable. Before installing or removing
the control panel, make sure that power is turned off and the power
cord is unplugged.
Tips & Tricks You may need to disconnect the ends of the front panel and USB
cables from the system board or backplane to create enough slack
in the cables to reach the connectors.