Replacing the power supply – Gateway 9315 User Manual
Page 85
80
www.gateway.com
Replacing the power supply
To replace the power supply:
1
Follow the instructions in
“Preventing static electricity discharge” on page 37
. Make
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
2
Follow the instructions in
“Opening the server case” on page 38
.
3
If you have a hot-swap backplane installed, follow the instructions in
4
Disconnect the power signal cable, main power cable, and the CPU power cables from
the system board.
5
Disconnect the flex cable and the 2×3 power cable from the backplane.
Warning
The power supply in this server contains no user-serviceable parts.
Only a qualified computer technician should service the power supply.
Your server comes with a 3-wire AC power cord fitted with the correct
plug style for your region. If this plug does not match the connector
on your surge protector, UPS, or wall outlet, do not attempt to modify
the plug in any way. Use a surge protector, UPS, or wall outlet that
is appropriate for the supplied AC power cord.
Flex cable
2×3 cable