Gateway 9315 - Manual (Page 88)

83 www.gateway.com
7
Loosen the blue captive screw on the right side of the backplane, then slide the
backplane to the right until it stops.
8
Lift the backplane from the server and place it in a static-free bag for future use.
9
Align the new backplane’s keyhole slots with the mounting posts on the floor of the
server case, then slide the backplane to the left until it stops.
10
Tighten the blue captive screw at the right side of the board to secure the backplane
to the server.
11
Connect all cables to the backplane.
12
Follow the instructions in “Installing the air baffle” on page 44 .
13
Follow the instructions in “Closing the server case” on page 39 .
14
Install the drives back into the server. If you are replacing the backplane, make sure
that you replace the drives in the same bays you removed them from in
Step 5 .
15
Reinstall the bezel (if required).
Caution Lift the backplane by the edges only. Damage may result if you pull
on any board components.