Gateway 9315 - Manual (Page 101)

96 www.gateway.com
5
Insert a DOS-bootable USB disk-on-key or DOS-bootable CD containing a valid BIOS
image.
6
Reconnect the power cords and turn on the server. The BIOS recovery is initiated.
While the BIOS is being recovered, the monitor displays a blue screen and the server
will beep continually. The process is complete when the server stops beeping.
7
Remove the bootable USB disk-on-key or CD.
8
Turn off the server, then disconnect the power cords and all other cables connected
to the server.
9
Follow the instructions in “Opening the server case” on page 38 .
10
Place the jumper back onto pins 2-3.
11
Follow the instructions in “Closing the server case” on page 39 .
12
Plug in the AC power cords and turn on the server, then verify that the recovery was
successful.