Beep codes – Gateway 9315 User Manual
Page 113
108
www.gateway.com
■
Remove the top panel by following the instructions in
, then make sure that all cables inside the case are attached securely. Also, make
sure that the colored cable edges are aligned correctly and that the connectors do not
miss any pins.
■
If you have the correct test equipment, make sure that the new battery has power.
Although unlikely, your new battery may be defective.
Beep codes
Whenever a recoverable error occurs during the power-on self-test (POST), the BIOS
displays an error message that describes the problem. The BIOS also sounds a beep code
(one long tone followed by two short tones) during POST if the video configuration fails
(a faulty video controller) or if an expansion card is not functioning correctly. One short
beep indicates the BIOS will boot the operating system. No error found.
A PCI expansion card (for example, a RAID controller) can also issue audible errors by itself,
usually consisting of one long tone followed by a series of short tones. For more
information on the beep codes issued, check the documentation for that device.
The following table shows POST error beep codes. Prior to system video initialization, BIOS
uses these codes to inform users of error conditions.
Warning
To avoid bodily injury, do not attempt to troubleshoot your server
problem if:
■
The power cord or plug is damaged
■
Liquid has been spilled into your server
■
Your server was dropped
■
The case was damaged
Instead, unplug your server and contact a qualified computer
technician or Gateway Customer Care.
Beeps
Description
Troubleshooting steps
1
Memory refresh timer error
Reseat the memory modules or replace with
modules you know are good.
2
Parity error in the first 64 KB of memory.
Same as for 1 beep.
3
Base memory read/write test error
Same as for 1 beep.