beautypg.com

Installing or replacing the hot-swap backplane – Gateway 9315 User Manual

Page 87

background image

82

www.gateway.com

Installing or replacing the hot-swap
backplane

Your server may not have a hot-swap backplane. If your server was ordered with fixed
drives, it will not have a hot-swap backplane.

To install or replace the hot-swap backplane:

1

Follow the instructions in

“Preventing static electricity discharge” on page 37

. Make

sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.

2

Remove the bezel by unlocking it, then pulling it straight off the front of the chassis.

3

Follow the instructions in

“Opening the server case” on page 38

.

4

Follow the instructions in

“Removing the air baffle” on page 42

.

5

Remove all drives and drive carriers by following the instructions in

“Installing or

replacing a hard drive” on page 53

. Make note of which bay you remove each drive

from.

If you are installing a hot-swap backplane for the first time, go to

Step 9

. Otherwise

go to the next step.

6

Disconnect all cables from the backplane.