Gateway 9315 User Manual
Page 19
14
www.gateway.com
To mount your server in a cabinet:
1
Remove the two screws from each handle, then set the handles and screws aside.
2
Align the slots in a server rail with the studs on the side of the server, then engage
the slots with the studs and slide the rail back until it stops. (Your server may be
different than the server shown in the example.)
3
Align the locking screw holes in the rails with the threaded screw holes in the server,
then install the two locking screws through each rail.
Server rail
Locking screw hole
Slot
Slot
Locking screw hole
Locking screw hole
Mounting stud