Force10 Networks PSeries 100-00055-01 - Manual (Page 92)

92 Appendix A
pnic help
Display a list of all available commands, their syntax, and descriptions.
Syntax pnic help
Command
History
Example Figure 56
[root@localhost SW]# pnic help
No card number specified. Assuming card 0
Usage: pnic function_command
pnic aggregate-mode-disable <0|...|5> pnic aggregate-mode-enable <0|...|5>
pnic apply-firmwares <0|...|5> <-f> pnic capture-off <0|...|5>
pnic capture-on <0|...|5> pnic cardstatus <0|...|5>
pnic compilerules <0|...|5> pnic default-drop-disable <0|...|5>
pnic default-drop-enable <0|...|5> pnic diag <0|...|5>
pnic getmachashindex <0|...|5> pnic gui <0|...|5>
pnic linkdown <0|...|5> <0/1> pnic linkup <0|...|5> <0/1>
pnic loadconf <0|...|5> pnic loadeproms <0|...|5>
pnic loadpassblock <0|...|5> pnic loadrules <0|...|5>
pnic macrewrite-off <0|...|5> <0/1> pnic macrewrite-on <0|...|5> <0/1>
pnic params <0|...|5> pnic passive-mode-enable <0|...|5>
pnic passive-mode-disable <0|...|5> pnic restart <0|...|5> <-f>
pnic showconf <0|...|5> pnic show-firmwares
pnic sguil-sensor-start pnic sguil-sensor-stop
pnic start <0|...|5> pnic stop <0|...|5>
pnic temp-mem-disable <0|...|5> pnic temp-mem-enable <0|...|5>
pnic updatemacvalue <0|...|5> pnic version
pnic web-gui-start pnic web-gui-stop
pnic help
Note:
<> : Option. Default (blank) values are "0"
: Select from 0, 1, 2, 3, 4, or 5
: Select from 0, or 1
: This option will skip the firmware revision check
Command Help:
aggregate-mode-enable Map both client-to-server and server-to-client traffic
on a channel
to the same flow state entry.
aggregate-mode-disable Map client-to-server and server-to-client traffic from
separate
channels to different flow state entries.
apply-firmwares Apply the selected firmware to the link that is
currently in use or
for loading
capture-off(off) Disable the capture of the packets via DMA.
capture-on(on) Enable the capture of the packets via DMA.
cardstatus Display the status of the ports, the revision number
of the PCI-X
FPGA, and the revision number of the Master FPGA.
compilerules Transform the dynamic Snort rules contained in /usr/
local/pnic/0/
rules.custom into binary code suitable for the DPI
processor.
default-drop-enable Enable firewall functionality.
default-drop-disable Disable firewall functionality.
diag Run diagnostic tests on the card.
getmachashindex Display the hash index value for a specific source and
destination
IP address combination.
linkup Enable the physical link.
[output omitted]
pnic help Command Example
Version 2.3.0.0 Introduced