Force10 Networks PSeries 100-00055-01 - Manual (Page 25)

P-Series Installation and Operation Guide, version 2.3.1.2 25
The GUI can be used to:
• Start and stop the DPI
• Load firmware
• Compile and load dynamic rules
• Manage the runtime parameters
• Manage the capture/forward policies for rules
Note: Using the GUI requires the super user privilege.
To invoke the GUI:
Runtime statistics are displayed after the pnic gui command is executed. If the FPGA is not loaded, the
display appears as shown in Figure 13 . If firmware is loaded, the display appears as in Figure 19 .
Chapter 4 Graphical User Interface
Step Task
1
Invoke the GUI by entering the command
pnic gui.
Note: The OS environment variables are set such that the
pnic gui command can be executed from any
path.