Pnic flow-teardown-disable, Pnic flow-teardown-enable – Force10 Networks PSeries 100-00055-01 User Manual
Page 88
88
Appendix A
pnic flow-teardown-disable
Configure the appliance to reset the state of the flow only upon a timeout. This is the default
behavior.
Syntax
pnic flow-teardown-disable
Command
History
Example
Figure 52
[root@localhost SW]# pnic flow-teardown-disable
No card number specified. Assuming card 0
*** Disabling Flow-Teardown on card:0 successful.
[root@localhost SW]#
pnic flow-teardown-disable Command Example
Usage
Information
The flow teardown feature is coupled with the firewall feature. When default drop mode is
enabled (command
pnic default-drop-enable
), the flow teardown is enabled by default.
When default drop mode is disabled (
pnic default-drop-disable
), the flow teardown is
disabled by default.
Related
Commands
pnic flow-teardown-enable
Configure the appliance to clear any existing state for a TCP connection in the state memory
when it receives a TCP packet with FIN and/or RST bit set.
Syntax
pnic flow-teardown-enable
Command
History
Version 2.3.1.2
Introduced
Disable firewall functionality. This is the default behavior.
Enable firewall functionality.
Version 2.3.1.2
Introduced