Force10 Networks PSeries 100-00055-01 - Manual (Page 35)

P-Series Installation and Operation Guide, version 2.3.1.2 35
You can manage and monitor the P-Series on the web using the Force10 Networks P-Series Node Manager.
Launching the P-Series Node Manager
Note: The Web-based GUI is best viewed with a minimum screen resolution of 1280x800. You must also
have Java Run Time Environment (JRE) installed with the “Use JRE X.Y.Z for ” option enabled
under Tool --> Internet Options --> Advanced tab when using either Internet Explorer 6 or 7.To launch the P-Series Node Manager:Chapter 5Web-based Management Note: The web-based GUI is supported on Linux only, which is the default OS, and requires software
version 2.3.0.0 or newer.StepTask1Enter the command pnic web-gui-start to enable the secure HTTP service on the P-Series (see Appendix A , on page 79).2Lauch the P-Series Node Manager in a web brower by entering https://ipaddress in the address bar, as shown in Figure 21.3Login using the username and password configured on your P-Series appliance. Pages: 1 … 33 34 35 36 37 … 132 wrong Brand wrong Model non readable See also other documents in the category Force10 Networks Hardware: Force10 TeraScale E-Series E1200i (105 pages) C-Series (5 pages) Sitemap
To launch the P-Series Node Manager:
Chapter 5 Web-based Management
Note: The web-based GUI is supported on Linux only, which is the default OS, and requires software
version 2.3.0.0 or newer.
Step Task
1
Enter the command pnic web-gui-start to enable the secure HTTP service on the P-Series (see
Appendix A , on page 79 ).
2
Lauch the P-Series Node Manager in a web brower by entering https://ipaddress in the address bar, as
shown in Figure 21 .
3
Login using the username and password configured on your P-Series appliance.