Force10 Networks PSeries 100-00055-01 - Manual (Page 104)

104 Appendix A
pnic resetconf
Reset the system configuration back to the default settings, which are located in
/SW/misc/pnic.conf.
Syntax pnic resetconf [ number]
Parameters
Command
History
Example Figure 69
[root@localhost ~]# pnic resetconf
No card number specified. Assuming card 0
Loading default configurations ...
Read from configuration file and apply to PNIC card...
Registers on master FPGA:
(0x10)0000 (0x14)0010 (0x18)0000
Registers on PCI FPGA:
(0x18)0100 (0x24)20788 (0x28)20788
DMA Capture : on
MAC rewrite : CH0 - disabled; CH1 - disabled
Default Drop packet : disabled
Temporary memory : enabled
Aggregate mode : enabled
Flow teardown : disabled
PHY passive mode : disabled
Vlan remove : disabled
Read out the registers that were just applied.
On MASTER FPGA
(0x10)00000000 (0x14)00000010 (0x18)00000000
On PCI FPGA
(0x18)00000100 (0x24)00020788 (0x28)00020788
DMA Capture : on
MAC rewrite : CH0 - disabled; CH1 - disabled
Default Drop packet : disabled
Temporary memory : enabled
Aggregate mode : enabled
PHY passive mode : disabled
Flow teardown : disabled
Vlan remove : disabled
Version : P_MAIN2.3.0.006
[root@localhost ~]#
pnic resetconf Command Example
pnic restart
• Stop capturing and matching
number
(OPTIONAL) Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.3.1.2 Introduced