Force10 Networks PSeries 100-00055-01 - Manual (Page 84)

84 Appendix A
Example Figure 45 pnic capture-on Command Example
root@# pnic macrewrite-on 0
No channel number specified. Assuming channel 0
*** Enabling MAC rewrite on card:0 channel:0 is successful!
[root@localhost SW]# pnic capture-on
No card number specified. Assuming card 0
Capture ON set successful.
[root@localhost SW]#
Related
Commands
pnic cardstatus
Display the status of the ports, the revision number of the PCI-X FPGA, and the revision
number of the Master FPGA.
Syntax pnic cardstatus [
number
]
Parameters
Command
History
Example Figure 46
[root@localhost SW]# pnic cardstatus
No card number specified. Assuming card 0
************************************************
----- Channel Port Connection Status -----
Card 0, Channel 0: UP, Active, RX/TX
Card 0, Channel 1: UP, Active, RX/TX
----- Mirror Port Connection Status -----
Card 0, Mirror Port 0: No Carrier
Card 0, Mirror Port 1: No Carrier
************************************************
PCI FPGA revision: 2.8
************************************************
Master FPGA is loaded, revision: 2.6
************************************************
Version : P_MAIN2.2.0.058
[root@localhost SW]#
pnic cardstatus Command Example
Related
Commands
pnic capture-off Disable the capturing of packets via direct memory access
(DMA).
number
(OPTIONAL) Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.0.0.1 Introduced
pnic showconf Display the configuration parameters of the system.
pnic version Display the driver version.