Force10 Networks PSeries 100-00055-01 - Manual (Page 108)

108 Appendix A
pnic showconf
Display configuration parameters of the card.
Syntax pnic showconf [ number ]
Parameters
Command
History
Example Figure 74
[root@localhost ~]# pnic showconf
No card number specified. Assuming card 0
DMA Capture : on
MAC rewrite : CH0 - disabled; CH1 - disabled
Default Drop packet : disabled
Temporary memory : enabled
Aggregate mode : enabled
PHY passive mode : disabled
Flow teardown : disabled
Vlan remove : disabled
####################### On MASTER FPGA #######################
Per Flow Packet Limit : unlimited
Timeout for Flow Garbage Collection : 16
Truncation after Match Packet : full packet
####################### On PCI FPGA #######################
DMA Burst Size : 1024 (Bytes)
DMA Flush Timer : 1 (ms)
Interrupt Frequency Timer : 1 (ms)
Version : P_PRIV2.3.0.010
pnic showconf Command Example
Related
Commands
pnic show-firmwares
List the available firmware images.
Syntax
pnic show-firmwares
number
Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.0.0.1 Introduced
pnic cardstatus Display the status of the ports, the revision number of PCI-X
FPGA, and the revision number of the Master FPGA.
pnic version Display the driver version.