Force10 Networks PSeries 100-00055-01 - Manual (Page 86)

86 Appendix A
Example Figure 48
[root@localhost SW]# pnic default-drop-disable
No card number specified. Assuming card 0
*** Disabling Default-Packet-Drop on card:0 successful!
*** Temporary memory enabled.
*** Flow teardown disabled.
[root@localhost SW]#
pnic default-drop-disable Command Example
pnic default-drop-enable
Enable firewall functionality.
pnic default-drop-enable [ number ]
Disable firewall functionality using the command pnic default-drop-disable .
Parameters
Command
History
Example Figure 49
[root@localhost SW]# pnic default-drop-enable
No card number specified. Assuming card 0
*** Enabling Default-Packet-Drop on card:0 successful.
*** Temporary memory disabled.
[root@localhost SW]# [root@localhost SW]# pnic default-drop-enable
No card number specified. Assuming card 0
*** Enabling Default-Packet-Drop on card:0 successful.
*** Temporary memory disabled.
*** Flow teardown enabled.
[root@localhost SW]#
pnic default-drop-enable Command Example
Usage
Information
Temporary memory is disabled while the firewall is enabled.
pnic diag
Run diagnostic tests on the card.
Syntax pnic diag [ number ] [ -v ]
number
(OPTIONAL) Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.2.0.0 Introduced