Pnic getmachashindex – Force10 Networks PSeries 100-00055-01 User Manual
Page 89
P-Series Installation and Operation Guide, version 2.3.1.2
89
Example
Figure 53
[root@localhost SW]# pnic flow-teardown-enable
No card number specified. Assuming card 0
*** Enabling Flow-Teardown on card:0 successful.
[root@localhost SW]#
pnic flow-teardown-enable Command Example
Usage
Information
The flow teardown feature is coupled with the firewall feature. When default drop mode is
enabled (command
pnic default-drop-enable
), the flow teardown is enabled by default.
When default drop mode is disabled (
pnic default-drop-disable
), the flow teardown is
disabled by default.
Related
Commands
pnic getmachashindex
Display the hash index value for a specific source and destination IP address combination.
Syntax
pnic getmachashindex [number]
Parameters
Command
History
Example
Figure 54
[root@localhost SW]# pnic getmachashindex
No card number specified. Assuming card 0
Please input the Source IP address [e.g. 192.168.15.22]: 10.14.122.21
Input the Destination IP address [e.g. 172.168.15.14]: 154.12.123.44
The hash index calculated for MAC rewrite is: 170 (0xaa)
[root@localhost SW]#
pnic getmachashindex Command Example
Usage
Information
Use this command with the MAC rewrite feature. This command displays the hash index
value for an IP address pairs.
Disable firewall functionality. This is the default behavior.
Enable firewall functionality.
number
Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.1.0.0
Introduced