FARGO electronic DTC400 - Manual (Page 89)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-32
Resolving a Headlift Motor or Sensor Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: The Printhead continuously cycles or does not cycle at all
• Printer Error State: Headlift Sensor is not detecting movement from the
Headlift Cam
• LCD Error Display: Head Lift Error
• Driver Monitor Error Display: General Error
Continued on the next page