Connecting the printer power, Connecting the printer power -7 – FARGO electronic DTC400 User Manual
Page 35
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1)
3-7
Connecting the Printer power
Follow this procedure. (Note: Do not connect the Printer’s USB cable until prompted during
the Printer Driver installation.)
Step Procedure
1
Plug the AC adapter power cable into the back of the Printer. See Display A.
2
Plug the wall power cable into the AC power adapter.
3
Plug the wall power cable into a standard 110VAC power outlet.
Display A – Shows back of Printer with AC power cable (below).