Print process errors, Print process errors -6 – FARGO electronic DTC400 User Manual
Page 63
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1)
4-6
Print Process Errors
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Resolving a Card Not Fed Error (Cards will not feed off the Hopper)
Step Procedure
1
Review the following information.
•
Symptom: Cards will not feed at all.
•
Printer Error State: Card is not being detected by the Card TOF Sensor 11
seconds after the initiation of a print job causing the Printer to produce an
error
•
LCD Error Display: Card Not Fed
•
Driver Monitor Error Display: Unable to Feed Card
Continued on the next page
I