FARGO electronic DTC400 - Manual (Page 81)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1) 4-24
Resolving a No Ribbon Installed Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
• Symptom: Printer errors out as soon as it receives data from PC
• Printer Error State: The Printer RFID Sensor is not receiving a signal from
the Ribbon
• LCD Error Display: No Ribbon
• Driver Monitor Error Display: No Ribbon Installed
Continued on the next page