FARGO electronic DTC400 User Manual
Page 113
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC400/DTC300/DTC300M Card Printer User Guide (Rev. 1.1)
5-3
Selecting the Defined Area(s) function (continued) ______________________ 5-77
Selecting the Defined Area(s) function (continued) ______________________ 5-78
Selecting the Defined Area(s) function (continued) ______________________ 5-79
Selecting the Defined Area(s) function (continued) ______________________ 5-80
Selecting the Defined Area(s) function (continued) ______________________ 5-81
Selecting the Defined Area(s) function (continued) ______________________ 5-82
Selecting the Print YMC under K and Print K Only options__________________ 5-83
Using the Printer Supplies tab ___________________________________________ 5-84
Reviewing the Ribbon Information _____________________________________ 5-85
Reviewing the Ribbon Level Indicator __________________________________ 5-86
Using the Printer Calibration Utility ______________________________________ 5-87
Using the Image Darkness Option ______________________________________ 5-88
Using the Print Top of Form Option ____________________________________ 5-89
Using the Print End of Form Option ____________________________________ 5-90
Using the Print Left of Form Option ____________________________________ 5-91
Using the Magnetic Encoder Voltage Offset Option ________________________ 5-92
Adjusting the Hi-Co Voltage Offset __________________________________ 5-93
Adjusting the Lo-Co Voltage Offset __________________________________ 5-94
Using the Mag Top of Form Option ____________________________________ 5-95
Using the Mag Top of Form Option (continued) _________________________ 5-96