FANUC Robotics America V7865* - Manual (Page 93)

93
PCI/PnP Setup
B
PCI/PnP Setup
Included in this screen is the control of internal peripheral cards, as well as various
interrupts and DMA channels. From this menu, the user can also determine if the
system’s plug-and-play is enabled or disabled.
NOTE: Changes in this screen can cause the system to malfunction. If problems are
noted after changes have been made, reboot the system and access the BIOS. From the
Exit menu select ‘
Load Failsafe Defaults ’ and reboot the system. If the system failure
prevents access to the BIOS screens, refer to Chapter One for instructions on clearing
the CMOS.
Below is a sample screen of the PCI/PnP menu.
v02.59 (C) Copyright 1985-2005, American Megatrends, Inc .
NOTE: Options shown may not be available on your system.
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Security Chipset Exit
Advanced PCI/PnP Settings NO: lets the BIOS
configure all the
devices in the system.
YES: lets the
operating system
configure Plug and
Play (PnP) devices not
required for boot if
your system has a Plug
and Play operating
system.
←→ Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
WARNING: Setting wrong values in below sections
may cause system to malfunction.
Clear NVRAM [No]
Plug & Play O/S
[No]
PCI Latency Timer [64]
Allocate IRQ to PCI VGA [Yes]
Palette Snooping [Disabled]
PCI IDE BusMaster [Enabled]
OffBoard PCI/ISA IDE Card [Auto]
IRQ3 [Available]
IRQ4 [Available]
IRQ5 [Available]
IRQ7 [Available]
IRQ9 [Available]
IRQ10 [Available]
IRQ11 [Available]
IRQ14 [Available]
IRQ15 [Available]
DAM Channel 0 [Available]
DMA Channel 1 [Available]
DMA Channel 3 [Available]
DMA Channel 5 [Available]
DAM Channel 6 [Available]
DAM Channel 7 [Available]
Reserved Memory Size [Disabled]