FUJITSU Sparc Enterprise Server T5440 - Manual (Page 49)

Manage the System 33
4. To cause the parameter change to take effect, type:
The system permanently stores the parameter change.
After you disable the ASR feature, it is not activated again until you re-enable it.
Related Information
■ “Enable Automatic System Recovery” on page 31
■ “Automatic System Recovery” on page 31
▼ View Components Affected by ASR
1. Log in to ILOM.
See “Log In to ILOM” on page 28 .
2. At the ILOM -> prompt, type:
In the show /SYS/component component_state command output, any devices
marked disabled have been manually unconfigured using the system firmware.
The command output also shows devices that have failed firmware diagnostics
and have been automatically unconfigured by the system firmware.
Related Information
■ “Disable Automatic System Recovery” on page 32
■ Unconfigure a Device Manually
■ “Configure a Device Manually” on page 35
Clearing Faults
This section describes clearing fault messages using ILOM. For detailed
troubleshooting information, see the system’s service manual.
ok reset-all
-> show /SYS/ component component_state