FUJITSU Sparc Enterprise Server T5440 - Manual (Page 30)

14 SPARC Enterprise T5440 Server Administration Guide • July 2009
Related Information
■ “Creating RAID Volumes” on page 14
■ “Removing Hardware RAID Volumes” on page 21
Creating RAID Volumes
This section contains:
■ “Create a Hardware Mirrored Volume” on page 14
■ “Create a Hardware Mirrored Volume of the Default Boot Device” on page 15
■ “Create a Hardware Striped Volume” on page 17
■ “Configure and Label a Hardware RAID Volume for Use in the Solaris Operating
System” on page 18
■ “Disk Slot Numbers” on page 20
▼ Create a Hardware Mirrored Volume
1. Verify which hard drive corresponds with which logical device name and
physical device name, using the raidctl command.
See “Disk Slot Numbers” on page 20 to locate the correct disk number.
2. Type the following command:
A message appears asking you to confirm the operation. For example:
# raidctl
No RAID volumes found.
# raidctl -c primary secondary
# raidctl -c c0t0d0 c0t1d0
Creating RAID volume c0t0d0 will destroy all data on member disks,
proceed
(yes/no)?