FUJITSU Image Scanner fi-6130 - Manual (Page 191)

8.1 Scanner Settings
Document check area
specification for
Multifeed Detection Selected range: This is
checked when limiting the
range of detecting
multifeeds. You can
determine if mulfifeed
detection is enabled or
disabled in the specified
area.
Checking of selected range Do not check
Enable/Disable (when the selected
range is checked)
Disable
Start: The start point of the
check area in length (mm)
from top edge of the
document is specified.
0 to 510 mm (with 2 mm increment) 0 mm
End: The end point of the
check area in length (mm)
from top edge of the
document is specified.
0 to 510 mm (with 2 mm increment) 0 mm
Intelligent Multi-feed
Function If photograph or something
is pasted on the document
and its size and/or position
are same, you can easily let
the scanner memorize its
size and/or position just
scanning the document. To
use this function, you need
to specify [Check
overlapping] at [Multifeed
detection] by the procedure
in Section " 8.4Multifeed
Detection ."
Manual mode/Auto mode 1/Auto
mode 2
Manual
mode
Specify whether or not to
remember the multifeed
pattern at power-off.
Remember/Do not remember Do not
remember
Number of paper
feeding retries Specify the picking retry
times when picking fails
during scanning.
1 to 12 7
Useful life counter When the Page counter
(Consumable counter)
described in Section " 5.2
How to Check and Reset the
Consumables Counters
"
exceeds the value specified
here, the counter back-
ground color becomes
yellow.
For each consumable
10,000 to 2,550,000 with 10,000
increment
200,000
Manual-feed timeout Specify the standby time
period. After the
predetermined time period
has elapsed, manual feeding
is canceled.
Disable/Enable
When enabled: 5, 10, 20, 30, 40, 50,
60, 70, 80, 90, 100, 110 (seconds)
Disable
Power SW Control Specify whether or not to
enable power switch.
Enable power switch/Disable power
switch/Enable USB power feeding
Enable
power switch
[Default] button
Resets the current settings to the factory setting.
[Savebutton
Saves contents of various settings onto the computer.
(Use this button to apply the same settings to other fi-6130 or fi-6230 scanners.)
ATTENTION
Saving outputs the EEPROM value currently written in the scanner. Click the [Apply] button
first if you have changed the value immediately before saving.
[Restore] button
Restores contents of the settings saved onto the computer back to the scanner.
file:////10.232.227.50/Manual/fi-6130_6230_Lynx3L/OG/R02/02_081030/contents/EN/08/c08_01_01.htm (4/5) [2008/10/30 15:15:00]