FUJITSU Image Scanner fi-6130 - Manual (Page 100)

3.12 Color/Monochrome Auto Detection
fi-6130 / fi-6230 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
3.12 Color/Monochrome Auto Detection
This scanner features automatic detection of color or black-and-white document scans (the term "scan," in this case, refers
to a produced image by scanning).
Scanning color documents produces color (or grayscale) images, and scanning black-and-white documents produces
black-and-white images.
* Depending on the application to use, this function may not work properly.
Configure Multi Image settings using the scanner driver.
The following shows the procedure to change settings in the setup dialog box of the FUJITSU TWAIN 32 Scanner Driver.
1. Place the document on the scanner.
For how to load documents on the ADF paper chute, see Section " 2.2 Loading Documents on the ADF for Scanning. "
For how to load documents on the Flatbed, see Section " 2.3 Loading Documents on the Flatbed for Scanning [fi-6230
only]. "
2. Launch ScandAll PRO.
From the [Start] menu, select [All Programs] → [Fujitsu ScandAll PRO] → [Fujitsu ScandAll PRO] in the order
presented. Then, ScandAll PRO starts up.
3. From ScandAll PRO, display the setup dialog box of FUJITSU TWAIN 32.
For information about how to display the scanner driver's setup dialog box, see Section " 2.6 How to Use ScandAll PRO. "
4. In the [TWAIN Driver] dialog box, mark the [Enable Multi Image] checkbox.
file:////10.232.227.50/Manual/fi-6130_6230_Lynx3L/OG/R02/02_081030/contents/EN/03/c03_12_01.htm (1/3) [2008/10/30 15:14:30]