Fortress Technologies ecure Wireless Access Bridge User Manual
Page 99

Fortress Bridge: Command-Line Interface
89
By default a single virtual access point (
vap 1
) is configured for
each radio. The SSIDs associated with these two primary
VAPs should never be left at their defaults (shown above).
SSID strings can be up to 32 characters long.
Configure VAP settings interactively by entering the
set
command with just the
vap
argument, where N is the VAP
number. The Bridge CLI presents one field at a time, and you
can either enter a new value for a given field or strike
Enter
↵
to
leave the value unchanged and go on to the next field.
You can reconfigure existing VAPs with the
set
command:
[VAP]>
set vap 1
SSID [String <= 32] (Base-11g):
0123xyz
[OK]
DTIM [1-255] (1):
Hide SSID [on|off] (off):
RTS Threshold [off|1-2345] (off):
Frag Threshold [off|256-2345] (off):
Only 11g [on|off] (off):
Security Suite [? for options] (fortress):
Committing changes...
Reboot is required. [Y|N]?
You can also use the
set
command interactively to configure
the same parameters for new VAPs.
Entering a dot (
.
) at the SSID prompt clears the SSID string.
The
Security Suite
field will accept any of eleven possible
entries, and the differing parameters required for each are
presented interactively once you have entered your selection.
The CLI provides a list of possible
Security Suite
options
when a question mark (
?
) is entered for the field. (
Security
Suite
options and the parameters required to configure them
are described in detail in Section 3.3.4).
[AP]>
vapcfg radio 1
[VAP]>
set vap 2
SSID [String <= 32] ():
0987abc
[OK]
DTIM [1-255] (1):
Hide SSID [on|off] (off): on
[OK]
RTS Threshold [off|1-2345] (off):
Frag Threshold [off|256-2345] (off):
Only 11g [on|off] (off):
Security Suite [? for options] (fortress):
?
Possible Security Suites: [fortress|clear|open-wep|shared-
wep|8021x|wpa|wpa-psk|
wpa2|wpa2-psk|wpa-mixed|wpa-mixed-psk]
Security Suite [? for options] (fortress):
wpa
[OK]
Rekey period [seconds] (600):
300
[OK]
Committing changes...
Reboot is required. [Y|N]??
Alternatively, you can use the
set vap
command with valid
switches and arguments to change the settings of any VAP: