2 reconfiguring network settings with sac, Reconfiguring network settings with sac – Fortress Technologies ecure Wireless Access Bridge User Manual

Page 119

109

[GW]>

set sac stop

SAC Stop Initiated. May take some time to complete...
Stopped SAC process successfully
Reboot_Of_Master(SrlNum:24656196)_Required_For_NewConfiguration(CfgId:19082)_To_Take_Into_Effect
Reboot_Of_SACPeer(SrlNum:24743196)_Required_For_Configuration_Change_From(OldCfgId:0)_To(NewCfgI
d:19082_To_Take_Into_Effect
Reboot_Of_SACPeer(SrlNum:24773196)_Required_For_Configuration_Change_From(OldCfgId:0)_To(NewCfgI
d:19082)_To_Take_Into_Effect

Disconnect all of the Bridges’ WAN ports from the switch/
hub used to connect them for the initial SAC operation.

Power cycle each network Bridge by disconnecting and
then reconnecting its external +48V DC power supply.

When all Bridges have rebooted, confirm the network
configuration with

show sac

[GW]>

show sac

SwabSerialNum:24656196
SwabConfigID:

19082

19082

|2|SAC_PEER_CONFIRMED|SAC_COMPLETE_4PEER|SAC_VER_PEGASUS_ARCH1

24743196|172.24.0.3|

19082

|1|SAC_PEER_CONFIRMED|SAC_COMPLETE_4PEER|SAC_VER_PEGASUS_ARCH1

The matching configuration IDs (

ConfigID

CfgID 19082

above) indicate that the networked Bridges are all
members of the same SAC group.

Confirm that all SAC group members are present on the
network with

show partners

[GW]>

show partners

MAC|DeviceId|State|Username|SessionID|IP|vlanID|computerName|activityCount
02:14:8C:08:24:82|E4106192950F2494|01||0|172.24.0.4|0||56
00:14:8C:08:2C:C2|557C81E5D6072CD4|01||0|172.24.0.3|0||56

The configured Fortress Bridge network is ready to be
deployed.

SAC commands are valid only in Gateway mode (refer to
Section 6.1.1 for more detail).

NOTE:

When SAC

network nodes use

Radio 1 in AP mode,
their SSIDs and channel
settings should not
match, even though
they can be set globally
with SAC. Use the

show

radio

and

show

vap

commands from the
Bridge CLIs of individu-
al network nodes to
view these SAC-config-
urable settings.

6.8.2

Reconfiguring Network Settings with SAC

Only Bridges in Normal (non-FIPS) operating mode can be
configured through SAC.

Once a network has been configured through SAC, you can
use the SAC function to change any of the SAC-configurable
parameters of the Fortress Bridges forming the network.

Because the channel setting and SSID of Radio 2 in all network
nodes must match, you can use the

show radio

and

show vap

commands on any network Bridge to view the current values of
these SAC-configurable settings (refer to sections 6.4.3 and
6.4.3.1, respectively).