1 adding trusted devices in the cli, 2 deleting trusted devices in the cli, 2 snmp settings in the cli – Fortress Technologies ecure Wireless Access Bridge User Manual

Page 110: Snmp settings in the cli

100

The commands that configure and delete Trusted Devices are
valid only in GW (gateway) mode (refer to Section 6.1.1 for
more detail).

NOTE:

Trusted De-

vices must be as-

signed static IP
addresses.

6.5.1.1

Adding Trusted Devices in the CLI

Add Trusted Devices with the

add

command, as follows:

[GW]>

add td {-n <name>} {-ip <IPaddr>} {-m <MACaddr>} {-p any|}

in which

name

is a descriptive identifier for the Trusted Device,

IPaddr

is the Trusted Device’s network address, and

MACaddr

its MAC address. The

-p

switch specifies, by number, the

port(s) accessible through the Trusted Device (comma
delimited, without spaces), or that

any

port is accessible

through the Trusted Device.

CAUTION:

Specify-

ing that

any

port

can access a TD can
pose a significant secu-
rity risk.

Maximize network security by specifying the narrowest
possible port access for Trusted Devices.

You must configure a name and IP and MAC addresses for a
Trusted Device when you add it to the Bridge configuration.

You can leave out

-p

(port sets) argument to establish default

values for these settings. Trusted Devices have no ports open
by default.

6.5.1.2

Deleting Trusted Devices in the CLI

Delete a single Trusted Device or all Trusted Devices from
Fortress Bridge management with the

del

command, as

follows:

[GW]>

del td

{|all}

6.5.2

SNMP Settings in the CLI

View the current SNMP configuration with

show

snmp

NOTE:

You cannot

configure SNMP

management on a For-
tress Bridge in

FIPS

op-

erating mode. Refer to
Section 3.6.1 for more
information about
Bridge operating modes
and to Section 6.4.5.5 for
details on changing it.

[GW]>

show snmp

Status:off
Contact:you@yourdomain
Location:Home
ROCommunity:public
RWCommunity:private

Enable SNMP (v1,2) management of the Fortress Bridge with
the

enable

command:

The Fortress MIB is included on the CD that shipped with the
Bridge and is also available from:

https://www.fortresstech.com/support/products_updates.asp

[GW]>

set snmp on

Disable SNMP on the Fortress Bridge with the

disable

command:

[GW]>

set snmp off

Configure the Fortress Bridge for use with SNMP (v1,2) with
the

set

commands: