beautypg.com

3 viewing the software version in the cli, 4 restarting the bridge in the cli, 6 monitoring and diagnostics in the cli – Fortress Technologies ecure Wireless Access Bridge User Manual

Page 111: 1 viewing a summary overview of the bridge, Monitoring and diagnostics in the cli, Viewing a summary overview of the bridge, In section 6.5.4), or f

background image

Fortress Bridge: Command-Line Interface

101

[GW]>

set snmp -c

<[email protected]>

-l

-ro

-rw

Set Contact:OK
Set Location:OK
Set RO Community:OK
Set RW Community:OK

in which

contact

is the e-mail address to which SNMP event

notifications will be sent,

locationName

identifies the Fortress

Bridge,

roCmntyName

identifies the SNMP read-only

community, and

rwCmntyName

identifies the SNMP read-write

community.

You can include spaces in the location and SNMP community
names by enclosing the input string in quotation marks.

The

show

snmp

and

set

snmp

commands are valid only in GW

(gateway) mode (refer to Section 6.1.1 for more detail).

6.5.3

Viewing the Software Version in the CLI

Display the firmware version currently running on the Fortress
Bridge with the command:

[GW]>

about

Fortress Interface Shell. Version:2.6.0.2500Y

The

about

command is valid in either AP (access point) mode

or GW (gateway) mode (refer to Section 6.1.1 for more detail).

6.5.4

Restarting the Bridge in the CLI

The

reboot

command does not power cycle the Bridge.

Restart the Fortress Bridge’s cryptographic processor with

reboot

, confirming your intention at the query, as follows:

NOTE:

The

reboot

command ends all

active sessions on the
Fortress Bridge.

[GW]>

reboot

Confirm: Reboot device now? [Y|N]

y

The system is going down NOW !!
Sending SIGTERM to all processes.
stopping watchdog
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Restarting system.

You can observe the Bridge stop its processor (as shown
above). You can also observe the Fortress Bridge rebooting.

The

reboot

command is valid in AP (access point) mode, its

VAP (virtual access point) submenu, or in GW (gateway) mode
(refer to Section 6.1.1 for more detail).

6.6 Monitoring and Diagnostics in the CLI

6.6.1

Viewing a Summary Overview of the Bridge

Obtain a basic overview of the Bridge configuration—including
hostname, Device ID, encryption, network address, and the
current settings for SSH and GUI access to the Bridge and
user authentication—with the command: