2 location of connectors – Furuno FSV-24 User Manual
Page 30
2-2
2.2
Location of Connectors
Monitor
(Local supply)
CONTROL UNIT FSV-2401
CONTROL UNIT FSV-2401
MONITOR UNIT
FSV-2400
PROCESSOR UNIT
FSV-2402/2402S
POWER SUPLY UNIT
FSV-242
TRANSCEIVER UNIT
FSV-241E
HULL UNIT
FSV-243E (1200 mm stroke)/
FSV-244E (1600 mm stroke)
10S2074 (10 m) or 10S2075 (30 m)
10S1258 (option)
Monitor cable
(Local supply)
DPYCY-4
10S2140 (15 m), 10S2141 (14.5 m)
10S2078 (8 m)
100/110/115/
220/230 VAC
1
φ
, 50/60 Hz
100/110/115/
220/230 VAC
1
φ
, 50/60 Hz
*2
*2: If connector may loosen by
vibration the monitor may also
be connected inside.
Processor unit clamp
Transceiver
unit
Monitor unit
Monitor unit
Control unit
Control unit
External
monitor
220 VAC
3
φ
, 50/60 Hz
10S2076 (5/10 m)
10S2076 (5/10 m)
DPYCY-1.5 *3
DPYCY
-4
*3
*3
TPYCY-4 *3
*4
*4
*3: Japan Industrial Standard cable
*4: The same type of connector is fitted at each end, however the connector where the amount of sheath
removed is greater should be connected to the transceiver unit.
*5: When running the cables of 10S2078, 10S2140 and 10S2141, refer to next page.
*6: When using cable for extension kit, the length of the cable between the transceiver unit
and the hull unit is 10 m or 20 m.
*5 *6
*5 *6
Interconnection