Setroute – FUJITSU M8000 User Manual
Page 257
setroute(8)
System Administration
235
NAME
setroute - set routing information for an XSCF network interface
SYNOPSIS
setroute -c
{add | del} -n address [-m address] [-g address] interface
setroute -h
DESCRIPTION
setroute
(8) command sets routing information for an XSCF network interface.
Up to eight routing information items can be registered for each network interface.
Any attempt to register more than eight items causes an error.
Privileges
You must have platadm privilege to run this command.
Refer to setprivileges(8) for more information.
OPTIONS
The following options are supported:
-c
{add|del}
Specifies a function for routing information. One of the following
values can be specified. If none of them is specified, an error
occurs.
add
Adds routing information.
del
Deletes routing information.
-g
address
Specifies a gateway address used for routing. The specified value
of address is a set of four integer values delimited by the "."
(period). If this option is omitted, the gateway address is not
set.The following address form is accepted:
xxx.xxx.xxx.xxx
xxx
An integer from 0–255. Zero suppression can
be used to specify the integer.